A multi-slide sill is supposed to get wet. It is not supposed to stay wet inside your house. That is the first thing I tell a Los Angeles homeowner who finds water in the track after rain and assumes the big Fleetwood wall has failed. A multi-slide sill is a drainage system, not a bathtub and not a sealed dam. Rain hits the glass, runs down into the tracks, collects in the sill, and is supposed to leave through the weep holes to the outside. When that path is clear, a wet track after a storm can be the system doing its job. When that path is blocked, buried, or overwhelmed, the same sill fills until water finds the only other way out — inside, at the floor.
How the sill is supposed to work
Open a multi-slide and look down. You will see several parallel tracks, one for each panel, separated by raised rails the rollers ride on. Water that gets past the outer panel — and in wind-driven rain, some always does — lands in those channels. The channels slope and connect toward weep holes: small slots or holes through the sill to the exterior, often covered outside by small weep covers that keep insects and wind-blown debris out while letting water out. The inside leg of the sill is the last line of defense. It is higher than the drainage channels for a reason, so pooled water drains out before it ever gets high enough to spill over that inside leg onto your floor. A leak at the sill, in other words, is rarely water coming through the glass. It is water that collected as designed and then could not leave.
The usual causes, in the order we check them
- Clogged weeps: Dirt, leaf litter, stucco droppings from construction, and spider webs pack into weep slots. One blocked weep can back up an entire track run, because the channels share the same low exit.
- Weeps buried or sealed from outside: New stucco, stone, decking, or landscaping raised against the sill can cover the exits. Caulk smeared over a weep by a well-meaning painter seals the drain shut. The door did not change — its drain was closed from the other side.
- Debris in the tracks: Grit, pet hair, and leaves in the channels act like a dam and hold water around the rollers instead of letting it run to the weeps. They also grind rollers and tracks every time the panel moves.
- Interlock and panel alignment: Where panels meet, vertical interlocks and weatherstripping slow wind-driven rain. A panel sitting low, out of plumb, or not fully closed leaves a gap that lets a storm push far more water in than the sill was asked to drain in that spot.
- Sill joints and end dams: At the ends of the sill and where frame sections join, sealant and end dams keep collected water from migrating sideways into the wall or under the flooring. Aged or missing seal at a joint leaks even when the weeps are clear.
- Slope and the surface outside: A patio, deck, or planter that slopes toward the door, or a drain outside that backs up, can push exterior water at the sill faster than any weep system can remove it — and can even reverse the flow through the weeps.
The checks you can do before you call
Wait for dry weather, open the panels, and look before you hose anything. Vacuum the tracks clean — do not wash debris deeper into the weeps. Find the weep holes inside the sill channel and their exits outside, and confirm each exit is open and uncovered; a thin, flexible probe clears most clogs, used gently so you do not push the blockage deeper. Pour a small cup of water slowly into the outermost track, away from the weeps, and watch: it should travel and appear outside within moments, not pool, and never rise toward the inside leg. Check that every panel closes fully and latches without lifting or forcing, and look at the flooring and baseboard at both ends of the sill — staining at an end points to a joint or end dam, while water in the middle points to drainage. Photograph what you find. Those photos tell a service tech more than “it leaked” ever will. Our Fleetwood windows and doors service starts with exactly this drainage picture, because Versa Glass Co., as an Authorized Fleetwood Dealer, services the system we sell and install — sill, weeps, panels, and hardware together.
What not to do
Do not caulk the weep holes shut, inside or out. That is the most common well-intentioned fix we undo, and it guarantees the next rain fills the sill. Do not caulk along the inside leg of the sill to “stop” water either — you will trap water in the frame and hide the real path until the floor or wall shows it. Do not blast the door with a hose at full pressure and call the result a leak test: a hose aimed up at the interlocks delivers water at angles and pressure rain rarely does, and it floods good doors. And do not ignore a sill that stays wet days after rain. Standing water corrodes rollers and hardware, stains tracks, and feeds the musty smell homeowners blame on the floor when it started in the frame.
When it is a service call, not a cleaning
- Water comes over the inside leg during ordinary rain, not just an extreme wind-driven storm.
- The cup test fails: water poured in the track does not exit outside, exits very slowly, or appears somewhere other than the weep exit.
- Leaking is at one end only, or there is swelling, staining, or soft flooring at a jamb — signs of a joint, end dam, or flashing problem behind the frame.
- Panels do not close, latch, or sit evenly, or weatherstripping at the interlocks is torn, flattened, or missing.
- It leaks in every rain, in the same place, after the tracks and weeps have been cleaned and verified open.
At that point the work is diagnosis in order: verify drainage, then panel fit and seals, then sill joints, then the installation conditions around the frame — pan, flashing, and the exterior surface against the sill. Skipping to the last step and tearing out a door whose weeps were clogged is how a service call becomes a construction project. Most sill water we are called for is a drainage or seal problem, and it is fixable as service — if it is found before water has had months to work on the floor and wall around it.
The short answer
A wet track after rain is information, not a verdict. If the water drains out through clear weeps and the inside of your home stays dry, the sill did its job. If water pools, rises, appears at the ends, or crosses the inside leg, the drain, the seals, or the joints need attention — in that order. Clear the path out first, and never seal it shut.
Fleetwood multi-slide holding water or leaking at the sill in Los Angeles? Call or text Versa Glass Co. with a photo of the sill track, a photo of the outside weep exits, and a note on where the water appeared. We will tell you whether it is a cleaning, a drainage service, or a joint repair, and quote the exact work.
Get a Quote Call (310) 847-9746